Boards, modules and pin rules come from the Build Finder but are simplified for play (prices are rough). Always check the datasheet and your own board's pinout before wiring real hardware.
Choose your ESP32
Buy modules
Your modules
How to play
- Pick a mission. Each one is a real project from the Build Finder. It tells you the parts you need, the features the board must have, and your budget.
- Shop. Choose an ESP32 board, then buy the modules. Cheaper boards leave money for parts, but they may lack Wi-Fi, Bluetooth, a camera or USB keyboard support, or have too few pins.
- Plug modules into the breadboard. On the bench, press Place on breadboard under a module, then tap a hole in column e or f. The module's pins go into the holes going down the rows, in the order listed in its Datasheet.
- Run jumper wires. Tap one end (a hole, or a pin on the ESP32), then tap the other end. Wires go from the ESP32 to the breadboard, or between two breadboard holes. Tap the × in the middle of a wire to remove it. Esc cancels what you are doing.
- Power on. The boot log lists every problem it finds. Fix them and try again until your project boots.
Breadboard basics
- The five holes a to e in one row are joined together (one strip). The five holes f to j in the same row are another strip. The centre gap keeps the two sides apart.
- The long columns at the far left and right are power rails: every hole in one rail is joined. Use them to share 3V3, 5V or ground between several parts.
- A module's pin takes up one hole. To reach it, use another hole in the same strip, which is the same row on the same side of the gap. Highlighted holes show everything joined to the one you tapped.
- Each hole holds one lead, so a crowded strip may need a different row.
What the power-on test checks
- Magic smoke (costs a replacement part, and a star): 5 V into a 3.3 V-only part, power and ground swapped, a 5 V ECHO signal into a GPIO with no voltage divider, or two supply pins joined by your wiring.
- Errors (nothing is damaged, but it will not boot): an unplugged or unwired pin, an analog sensor on an ADC2 pin while Wi-Fi is on, an input-only pin used as an output, I2C or SPI on the wrong pins, two signals sharing one GPIO.
- Warnings (it works but you lose a star): boot strapping pins, or a servo or LED strip powered from the board's own 5V pin instead of the bench supply.
Scoring
One star for a working build. A second star for no smoke and no warnings. A third star for staying within budget, counting the board, every part you bought and any replacements. The sandbox has no budget or stars.
Stuck?
Press Hint on the bench. You get three levels for whatever step is next: what to do, how to do it, then the exact answer. Levels one and two are free. The exact answer (hint 3), the full wiring diagram below and the auto-wire button all cap the mission at two stars.
Parts and pins follow the Build Finder but are simplified for play, and prices are rough. Always check the datasheet and your own board's pinout before wiring real hardware.